How to press the standard 4-fiber network wire, press the standard connection cable

The normal network wire is clicked according to the connection standard with 8 seconds, supporting the RJ45 type of connector. But did you know that using this phone is a standard 4-fiber network wire as in the article we are talking about, the wire can also be used to connect to the network.

Maybe you do not know other than using the usual ways to click network cablestandard wire type support RJ45 . lattice beads with 8 primary colors we can too standard 4 fiber network cable. There are many questions about whether the standard 4-fiber network cable is safe as well as ensuring your connection. If you try to use it, you will see almost no difference in the home network model or small networks.

Of course, Emergenceingames.com also does not encourage you to use it how to press 4 fiber network wire This standard applies to corporate systems where there are many switches, modems or routers in the system. You should only consider the standard 4-fiber network cable as a temporary solution in case there is no 8-color wire to press the network cable for the system.

Instructions on how to press the standard 4-fiber network wire, press the standard connection cable.

Step 1: Before proceeding to press the standard 4-strand network wire, you first need to prepare a full set of tools including the following tools:

– RJ45 standard network wire pliers, popular today
– Specialized wire cutters, can be replaced with pliers.
– RJ45 network switch (common type), the most common standard today for home and corporate network systems.
– Arbitrary type network cable, product price is about 5,000 / for one meter CAT 5E

Next we need to pay attention to the two standards, T568A or T568B in the figure, but not according to these two standards, but we remember the order of positions. Because with only 4 wires, we will not be able to fill 8 holes, instead we will only fill positions 1 2 3 and 6.

Step 2: Proceed to use a knife, scissors or use pliers to cut off the cover of the network wire. Note that only the outer protective cover is cut, do not cut the sheath of the inner wires.

Step 3: Then you proceed split wireto press the standard 4-fiber network wire you should put 2 white wires on both sides and in the middle are 2 colored wires in the order of orange and green wires.

Step 4: Next, you straighten the wire and then cut off the excess to easily insert into the net.

Step 5: Next, put the wire in positions 1 2 3 6 as shown above and then use network pliers to press firmly.

Step 7: Finally, take out your test device and try again to see if the connections are stable. If all lights are on, it means that you have completed the standard 4-fiber network wiring.

https://thuthuat.Emergenceingames.com/cach-bam-day-mang-4-soi-chuan-23144n.aspx
Above are all the steps to press the standard 4-wire network cable, the above article can be applied to perform network wiring without having to buy ready-made wires or ask a technician to press for a price 2 times higher. , 3 times the usual. In addition, if you want to learn more about how to stick to the network wire connecting 2 switches so that it is standard, please refer to the article on how to click the network wire to connect 2 switches made by Emergenceingames.com.